Swecoin TTP 5200, Service Manual

Page: 18 / 52

TTP 52x0 Series Kiosk Printer — Service Manual December 2001 16
3.3.5 Print module
REMOVAL
1. Tilt the print module by pulling the green handle backwards.
2. Remove the two screws holding the print module to the hinge plate.
3. Cut the tiewrap holding the cables to the hinge plate.
4. Disconnect the ribbon cable from the printhead.
5. Loosen the lower chassis module and disconnect the motor and sensor-cables from
the control board.
6. Remove the print module.
SW96147B
Green Handle
Print Module
Screws
Figure 5. Loosening the print module
REPLACEMENT
1. Install the print module in the reverse order
2. Fit new tie wraps
3. Remember to move the green handle over to the replacement print module