A-96.250.491 / 190121
AMI Deltacon DG
Program List and Explanations
57
2.2.1.3
Sensor 3
: Shows the
Current value
in µS
Raw value
in µS
Cell Constant
2.2.2
Miscellaneous
:
2.2.2.1
Case Temp:
Shows the current temperature in [°C] inside the trans
-
mitter.
2.2.4
Degasser
2.2.4.1
Heater: Current sample temperature in °C.
Boiling point: Value of the last calculated boiling point in °C.
PWM: Heating power in %.
Line Voltage: Current degasser voltage in V
Air pressure: Current local air pressure in hPa.
Case Temp.: Current temperature in the transmitter housing.
2.2.5
Boiling Point
The boiling point depends on the air pressure and is therefore auto
-
matically recalculated in configurable intervals (default: 6 hours).
Each calculation is stored and numbered and can be viewed in the
history with date, time, boiling point, air pressure and sample flow.
2.2.5.1
Number: Counter of the boiling point calculations.
Date, Time: Date and time for each boiling point calculation.
Boiling point: Boiling point at this date.
Air pressure: Air pressure at this date.
Sample flow: Sample flow at this date.
2.3 Sample
2.3.1
Sample ID
:
Shows the identification assigned to a sample. This iden
-
tification is defined by the user to identify the location of the sample.
2.3.2
Sample Flow
: Shows the current sample flow in l/h and the raw
value in Hz.
2.3.3
Sample Temp:
2.3.3.1
Temp 1:
Shows the current sample temperature at sensor 1 in °C.
(Pt 1000)
: Shows the current temperature at sensor 1 in Ohm.
Temp 2:
Shows the current sample temperature at sensor 2 in °C.
(Pt 1000)
: Shows the current temperature at sensor 2 in Ohm.
Temp 3:
Shows the current sample temperature at sensor 3 in °C.
(Pt 1000)
: Shows the current temperature at sensor 3 in Ohm.
Resin capacity: Shows the remaining resin capacity in %.
Change of Resin: Shows the date of the last resin changing.
