Suzuki UK110NE 2015, Owner'S Manual

Page: 132 / 144

8-6
NOTE: Avoid spraying or allowing water to
flow over the following places:
•
Ignition switch
• Spark plug
• Fuel tank cap
• Fuel injection system
• Brake master cylinder
• Throttle cable boots
3. Once the dirt has been completely
removed, rinse off the detergent with
running water.
4. After rinsing, wipe off the motorcycle
with a wet chamois or cloth and allow it
to dry in the shade.
5. Check carefully for damage to painted
surfaces. If there is any damage, obtain
“touch-up” paint and “touch-up” the dam-
age following the procedure below:
a. Clean all damaged spots and allow
them to dry.
b. Stir the paint and “touch-up” the dam-
aged spots lightly with a small brush.
c. Allow the paint to dry completely.
NOTICE
High pressure washers such as those
found at coin-operated car washes have
enough pressure to damage the parts of
your motorcycle. It may cause rust, cor-
rosion and increase wear. Parts cleaner
can also damage motorcycle parts.
Do not use high pressure washers to
clean your motorcycle. Do not use parts
cleaner on throttle body and fuel injec-
tion sensors.