PERIODIC MAINTENANCE 2-7
AIR CLEANER
AIR CLEANER ELEMENT REMOVAL
• Remove the seat. (
!
3-2)
• Remove screw
1
.
• Remove the element from the element holder.
WASHING
• Fill a washing pan that is large enough to hold the element
with non-flammable cleaning solvent
A
. Immerse the element
in the solvent and wash it.
• Squeeze the element by grasping it to remove excess sol-
vent. Do not twist or wring the element, or it will develop
cracks.
• Dry the element in a plastic bag, pour in some foam filter oil
B
and work the oil into the element.
• Squeeze the element to remove excess oil.
INSTALLATION
• Apply grease to the element base where contacts the air
cleaner box.
• Fit the element onto the element holder.
NOTE:
Fit the projection of the element holder in the hole of the element
base.
• Install the reassembled element to the air cleaner box so that
the projection of the element aligned with the projection of the
box.
CAUTION
Improper element installation allows dust and dirt to
enter the combustion chamber. It can result in piston
and cylinder wear.
Be sure to check the element seals properly after
installing the elements.
Summary of Contents for RM 250 2003
