Rear Brakes: 4C-5
11) Remove the bearing with the special tool.
Special tool
(C): 09921–20240 (Bearing remover set)
12) Remove the side plate stopper (13).
13) Remove the side plate (14), pins (15) and springs
(16).
14) Separate the friction plates (17) and separator plates
(18).
Assembly
CAUTION
!
The removed oil seal, bearing and snap ring
must be replaced with new ones.
• Install the rear brake in the reverse order of
disassembly. Pay attention to the following points:
• Assemble the rear brake plates as shown in the
figure.
CAUTION
!
Replace the remove side plate stopper (4)
with a new one.
• Apply final gear oil to the bearing (5) before installing
it.
• Install the bearing with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
NOTE
The stamped mark of bearing faces outside.
• Install the snap ring (6).
(C)
I831G1430019-02
13
14
16
15
I831G1430043-03
17
18
I831G1430021-01
1. Separator plate
4. Side plate stopper
2. Friction plate
“A”: Direction of out side
3. Side plate
“A”
3
3
2
1
4
4
I831G1430022-04
(A)
5
6
I831G1430023-03
Summary of Contents for kq750 2008
