SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
9
Installing Your Hardware
the optimum direction is found.
Once the outside antenna is secured to a pipe or pole, connect antenna to cable connector of end of the 75 ft.
length of cable and run along route to planned location of your booster.
Outdoor Yagi
Planned
booster
location
Outdoor
Cable
Outside Antenna Assembly
Nut
Washer
U-bolt
Bracket
Drip Hole
RG6 Cable
Installing an Omni Antenna
The omni antenna is omni-directional, which receives and sends signals in a 360º radius. The provided hardware
allow for either a surface mount or pole-mount. The antenna should be mounted in an upright position. See
illustration.
Note: Do not collocate antennas or operate the outdoor antenna with any other antenna or signal booster.
Mount antenna to a vertical surface:
1. Using vertical plate of bracket, mark position of desired placement. The omni antenna should be mounted in
an upright position (See
“Outside Antenna Assembly” on page 9)
2. Unscrew nut from end of stucco screw and remove it along with lock washer and regular washer.
3. Place vertical plate into desired location and tap the screws, head first, along with sleeve, into stucco 1/2 to
5/8 inches deep into place.
4. In this order, place washer, lock washer and nut on each screw and tighten until secure. When tightening
screw, sleeve will expand to secure plate.
5.
Remove screws from antenna base and use to secure antenna onto horizontal plate.
6.
Connect antenna to end of cable and run along route to planned location of your booster.
