Supero SuperWorkstation 7046A-6, User Manual

Page: 66 / 98

6-8
S
uper
W
orkstation 7046A-6 User's Manual
Installing Components in the 5.25" Drive Bays
The 7046A-6 has three 5.25" drive bays. Components such as SATA hard drives or
DVD/CD-ROM drives can be installed into these 5.25" drive bays.
Removing the Empty Drive Bay
First power down the system. 1.
Remove the top/left chassis cover to access the drive components. 2.
With the cover off, remove the screws that secure the drive carrier to the 3.
chassis (one side only) then push the entire empty drive carrier out from the
back.
Adding a DVD/CD-ROM Drive
Remove the guide plates (one on each side) from the empty drive carrier 1.
and screw them into both sides of the DVD/CD-ROM drive using the holes
provided.
Slide the DVD/CD-ROM into the bay and secure it to the chassis with the 2.
drive carrier screws you fi rst removed.
Attach the power and data cables to the drive. 3.
Replace the top/left chassis cover and restore power to the system. 4.
Adding a SATA Drive
Install an SATA drive into one of the removed empty drive carriers. 1.
Secure the drive to the carrier with screws then slide the assembly into 2.
the bay and secure it to the chassis with the drive carrier screws you fi rst
removed.
Attach the power and data cables to the drive. 3.
Replace the top/left chassis cover and restore power to the system. 4.
Note: Drive carriers should remain in any empty drive bays to maintain proper
airfl ow within the chassis.