1-2
SUPERSERVER 8047R-TRF+/7RFT+ USER'S MANUAL
•
If you have any questions, please contact our support team at
support@
supermicro.com
1-2 Serverboard
Features
At the heart of the SuperServer 8047R-TRF+/7RFT+ lies the X9QRi-F+/X9QR7-TF+,
a dual processor serverboard based on the Intel C602 chipset. Below are the main
features of the X9QRi-F+/X9QR7-TF+. (See Figure 1-1 for a block diagram of the
chipset).
Processors
The X9QRi-F+/X9QR7-TF+ supports E5-4600 (V2) Series processors in
Socket R-LGA 2011 type sockets. Each processor supports two full-width Intel
QuickPath Interconnect (QPI) links (Data Transfer Rate of up to 8.0 GT/s per
direction) Please refer to our web site for a complete listing of supported processors
(
www.supermicro.com
).
Note:
In order to install the E5-4600 (V2) Series CPU, you must make sure that
BIOS 3.0 version is installed to your system.
Memory
T h e X 9 Q R i - F + / X 9 Q R 7 - T F + h a s t h i r t y - t w o ( 3 2 ) s i n g l e / d u a l /
tri/quad channel 240-pin DIMM sockets that can support up to 1024GB
of Registered (RDIMM), Load Reduced (LRDIMM) ECC or Unbuffered
(UDIMM) ECC/Non-ECC DDR3 1866/1600/1333/1066/800 MHz speed
S D R A M i n a t w o - c h a n n e l m e m o r y b u s . M e m o r y s i z e s o f
1GB, 2GB, 4GB, 8GB, 16GB and 32GB size @ 1.35V/1.5V voltages are
supported. Please refer to Chapter 5 for installing memory.
Serial ATA
An on-chip (Intel C602) SATA controller is integrated into the X9QRi-F+/X9QR7-TF+
to provide a six-port SATA subsystem (two SATA 3.0 and four SATA 2.0 ports),
which is either RAID 0 and 1 (SATA3) or RAID 0, 1, 5, and 10 (SATA2) Windows/
LINUX supported. The SATA drives are hot-swappable units.
Note:
You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.
