Supero SUPERSERVER 6035B-8R+, User Manual, Page: 71 / 110

Chapter 6: Advanced Chassis Setup
6-9
6-5 Power Supply
The SuperServer 6035B-8R+ has an 800 watt redundant power supply consisting
of two power modules. Each power supply module has an auto-switching capabil-
ity, which enables it to automatically sense and operate at a 100V - 240V input
voltage.
Power Supply Failure
If either of the two power supply modules fail, the other will take the full load and
allow the system to continue operation without interruption. The PWR Fail LED will
illuminate and remain on until the failed module has been replaced. Replacements
can be ordered directly from Supermicro (see contact information in the Preface).
The power supply modules have a hot-swap capability, meaning you can replace
the failed module without powering down the system.
Removing/Replacing the Power Supply
You do not need to shut down the system to replace a power supply module. The
backup power supply module will keep the system up and running while you replace
the failed hot-swap module. Replace with the same model (see part number in the
Appendix), which can be ordered directly from Supermicro.
1. Removing the power supply
First unplug the power cord from the failed power supply module. Then depress
the locking tab on the power supply module and use the handle to pull it straight
out of the chassis.
2. Installing a new power supply
Replace the failed module with another by simply pushing the new power supply
module into the power bay until you hear a click. Secure the locking tab on the unit
and fi nish by plugging the AC power cord back into the module. See Figure 6-6.