Supero SUPERSERVER 6035B-8R+, User Manual, Page: 24 / 110

2-8
S
UPER
S
ERVER 6035B-8R+ User's Manual
2-5 Checking the Serverboard Setup
After you install the 6035B-8R+ in the rack, you will need to open the unit to
make sure the serverboard is properly installed and all the connections have been
made.
1. Accessing the inside of the System (see Figure 2-5)
First, release the retention screws that secure the unit to the rack. Grasp the two
handles on either side and pull the unit straight out until it locks (you will hear a
"click"). Next, depress the two buttons on the top of the chassis and push the cover
toward the rear of the chassis to release it. You can then lift the cover from the
chassis to gain full access to the inside of the server.
2. Check the CPUs (processors)
You may have one or two processors already installed into the serverboard. Each
processor needs its own heatsink. See Chapter 5 for instructions on processor and
heatsink installation.
3. Check the system memory
Your server system may have come with system memory already installed. Make
sure all DIMMs are fully seated in their slots. For details on adding system memory,
refer to Chapter 5.
4. Installing add-on cards
If desired, you can install add-on cards to the system. See Chapter 5 for details
on installing PCI add-on cards.
5. Check all cable connections and airfl ow
Make sure all power and data cables are properly connected and not blocking the
chassis airfl ow. Also make sure that no cables are positioned in front of the fans.
See Chapter 5 for details on cable connections.