Supero SUPERSERVER 6035B-8R+, User Manual, Page: 38 / 110

5-4
S
UPERSERVER 6035B-8R+ User’s Manual
Warning!
We do not recommend removal of the heatsink. However,
if you do need to uninstall the heatsink, please follow the instructions
below to prevent damage to the CPU or the CPU socket.
!
Installing the Heatsink
CEK Passive Heatsink
Screw#1 Screw#2
Screw #1
1. Do not apply any thermal grease
to the heatsink or the CPU die; the
required amount has already been
applied.
2. Place the heatsink on top of the CPU
so that the four mounting holes are
aligned with those on the (preinstalled)
heatsink retention mechanism.
3. Screw in two diagonal screws (i.e.
the #1 and the #2 screws) until just
snug. Do not fully tighten the screws
or you may damage the CPU.)
4. Add the two remaining screws then
fi nish the installation by fully tightening
all four screws.
Screw #2
Removing the Heatsink
1. Unscrew and remove the heatsink screws from the motherboard in the sequence as
shown in the third diagram above.
2. Hold the heatsink as show in the second diagram above and gently wriggle the
heatsink to loosen it from the CPU. (Do not use excessive force when wriggling the
heatsink!!)
3. Once the heatsink is loose, remove it from the CPU.
4. Clean the surface of the CPU and the heatsink to get rid of the old thermal grease.
Reapply the proper amount of thermal grease on the surface before you re-install the
heatsink.
Screw #3
Screw #4