Supero SUPERSERVER 6014P-8, User Manual

Page: 69 / 126

Chapter 6: Advanced Chassis Setup
6-9
6014P-8/6014P-82
The SuperServer 6014P-8/6014P-82 has a single 560 watt cold-swap
power supply, which is auto-switching capable. This enables it to auto-
matically sense and operate with a 100v - 240v input voltage. An amber
light will be illuminated on the power supply when the power is off. An
illuminated green light indicates that the power supply is operating.
Power Supply Failure
If the power supply module fails, the system will shut down and you will
need to replace the module. Replacements can be ordered directly from
Supermicro (see contact information in the Preface). As there is only one
power supply module in the 6014P-8, power must be completely removed
from the server before removing and replacing the power supply for what-
ever reason.
Removing/Replacing the Power Supply
1. Removing the power supply
First turn the power switch on the control panel off, then unplug the power
cord from the system. To remove the failed power module, first locate the
colored release tab (1). Push the tab to the right (2) and then pull the
module straight out with the handle provided (3) (Figure 6-5). The power
supply wiring was designed to detach automatically when the module is
pulled from the chassis.
2. Installing a new power supply
Replace the failed power supply with another SP562-1S power supply mod-
ule (p/n PWS-0057). Carefully insert the new power supply into the open
bay and push it completely into the chassis until you hear a clicking sound,
meaning it has been fully inserted. Finish by reconnecting the AC power
cord and depressing the power button on the chassis front control panel.