Supero SuperServer 4027GR-TR, User Manual

Page: 75 / 135

Chapter 5: Advanced Serverboard Setup
5-25
TPM Header/Port 80
A Trusted Platform Module/Port 80
header is located at JTPM1 to provide
TPM support and Port 80 connection.
Use this header to enhance system
performance and data security. See the
table on the right for pin de
fi nitions.
TPM/Port 80 Header (JTPM1)
Pin Defi nitions
Pin# De fi nition Pin# De fi nition
1 LCLK 2 GND
3 LFRAME# 4 <(KEY)>
5 LRESET# 6 +5V (X)
7 LAD 3 8 LAD 2
9 +3.3V 10 LAD1
11 LAD0 12 GND
13 SMB_CLK4 14 SMB_DAT4
15 +3V_DUAL 16 SERIRQ
17 GND 18 CLKRUN# (X)
19 LPCPD# 20 LDRQ# (X)
Overheat LED/Fan Fail
The JOH1 header is used to connect
an LED indicator to provide warnings
of chassis overheating and fan failure.
This LED will blink when a fan failure
occurs. Refer to the tables on right for
pin de
fi nitions.
Overheat LED
Pin Defi nitions
Pin# De fi nition
1 P3V3
2 OH Active
Low Signal
OH/Fan Fail LED
Status
State Message
Solid Overheat
Blinking (1Hz) Fan Fail
Blinking (0.25Hz) PWR Fail
T-SGPIO
Pin Defi nitions
Pin# De fi nition Pin# De fi nition
1 NC 2 NC
3 Ground 4 Data
5 Load 6 Ground
7 Clock 8 NC
Note:
NC= No Connection
T-SGPIO1/2/-S1 Headers
Two T-SGPIO (Serial-Link General Purpose
Input/Output) headers (T-SGPIO1/2/-S1)
are located on the serverboard. These
headers support a Serial Link interface for
onboard SATA connections. See the table
on the right for pin de
fi nitions.