Supero SUPERSERVER 1026TT-IBQF, User Manual

Page: 36 / 102

5-2
S
UPER
S
ERVER 1026TT-TF/1026TT-IBXF/1026TT-IBQF User's Manual
Unpacking
The serverboard is shipped in antistatic packaging to avoid electrostatic discharge.
When unpacking the board, make sure the person handling it is static protected.
5-2 Serverboard Installation
This section explains the fi rst step of physically mounting the X8DTT-F/X8DTT-IBXF/
X8DTT-IBQF into the SC809TQ-1200B chassis. Following the steps in the order
given will eliminate the most common problems encountered in such an installation.
To remove the serverboard, follow the procedure in reverse order.
Accessing the Inside of the System
Remove all four screws securing the top cover of the chassis: two at the top 1.
rear of the cover and one on each side lip, also near the back.
Place both thumbs in the indentations and push the cover back until it slides 2.
off.
Lift the top cover from the chassis to gain full access to the inside of the 3.
server. (If already installed in a rack, grasp the two handles on either side and
pull the unit straight out until the rails lock into place. See Figure 2-5.)
Check Compatibility of Serverboard Ports and I/O Shield
The X8DTT-F/X8DTT-IBXF/X8DTT-IBQF in a Twin 1U confi guration requires 1.
the use of Supermicro's 1U Twin chassis: the SC809TQ-1200B.
Make sure that the I/O ports on the serverboards align properly with their 2.
respective holes in the I/O shield at the back of the chassis when installing.
Mounting the Serverboard onto the Serverboard Tray
Carefully mount the serverboards by aligning the board holes with the raised 1.
metal standoffs that are visible in the chassis.
Insert screws into all the mounting holes on your serverboards that line up 2.
with the standoffs and tighten until snug (if you screw them in too tight, you
might strip the threads).
Metal screws provide an electrical contact to the serverboard ground to pro- 3.
vide a continuous ground for the system.