Supero Supero SUPERSERVER 6016T-T, User Manual

Page: 52 / 102

5-18
S
UPER
S
ERVER 6016T-T User's Manual
SGPIO Headers
Two SGPIO (Serial General Purpose
Input/Output) headers are included on
the serverboard. These headers are
used to communicate with the System
Monitoring chip on the backplane and
provide a serial interface to the SATA
ports. See the table on the right for pin
defi nitions.
SGPIO Headers Pin Defi nitions
Pin# Defi nition Pin Defi nition
1 NC 2 NC
3 Ground 4 DATA Out
5 Load 6 Ground
7 Clock 8 NC
Note: NC indicates no connection.
Power LED/Speaker
On the JD1 header, pins 1-3 are for
a power LED and pins 4-7 are for the
speaker. See the table on the right for
speaker pin defi nitions.
Note: The speaker connector pins are
for use with an external speaker. If you
wish to use the onboard speaker, you
should close pins 6-7 with a jumper.
Speaker Connector
Pin Defi nitions
Pin Setting Defi nition
Pins 4-7 External Speaker
Pins 6-7 Internal Speaker
Onboard Speaker (SP1)
The onboard speaker provides audible
indications for various beep codes.
See the table on the right for pin defi ni-
tions.
Internal Buzzer
Pin Defi nition
Pin# Defi nitions
Pin 1 Pos. (+) Beep In
Pin 2 Neg. (-) Alarm
Speaker
PWR LED Connector
Pin Defi nitions
Pin Setting Defi nition
Pin 1 Anode (+)
Pin2 Cathode (-)
Pin3 NA
I-Button
An onboard I-Button, located next to
USB Ports 2~3, is an 1-wire computer
chip enclosed in a durable stainless
steel can. The I-Button stores instruc-
tions, provides electronic interface
and allows the HostRAID to operate
with Mega-RAID fi rmware.