Supero Supero SUPERSERVER 6016T-T, User Manual

Page: 83 / 102

Chapter 7: BIOS
7-15
Plug & Play OS
Selecting Yes allows the OS to confi gure Plug & Play devices. (This is not required
for system boot if your system has an OS that supports Plug & Play.) Select No to
allow the AMI BIOS to confi gure all devices in the system.
PCI Latency Timer
This feature sets the latency Timer of each PCI device installed on a PCI bus. Select
64 to set the PCI latency to 64 PCI clock cycles. The options are 32, 64 , 96, 128,
160, 192, 224 and 248.
PCI IDE BusMaster
When enabled, the BIOS uses PCI bus mastering for reading/writing to IDE drives.
The options are Disabled and Enabled.
PCI SERR Function
The feature allows SERR errors detected in PCI slots to be sent (forwarded) to
the BIOS DMI Event Log for the user to review. The options are Enabled and
Disabled .
Slot 1 PCI 33MHz, Slot 2 PCI 33MHz, Slot 3 PCIE X4 in X8 Slot, Slot 4 PCIE
X8, Slot 5 PCIE X8, Slot 6 PCIE X8 in X16 slot
This feature allows you to Enable or Disable any of the PCI slots. The options
are
Enable and Disable.
Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM
Select Enabled to enable the onboard LAN1 or LAN2 Option ROM. This is to boot
computer using a network interface. The options are Enabled and Disabled.
X
Super IO Device Confi guration
Uart 2 of Hermon as
This feature sets COM2 as a normal serial port or a virtual COM port for SOL. The
options are SOL and COM.
Serial Port1 Address/ Serial Port2 Address
This option specifi es the base I/O port address and the Interrupt Request address
of Serial Port 1 and Serial Port 2. Select Disabled to prevent the serial port from
accessing any system resources. When this option is set to Disabled, the serial port
physically becomes unavailable. Select 3F8/IRQ4 to allow the serial port to use 3F8
as its I/O port address and IRQ 4 for the interrupt address. The options for Serial
Port1 are Disabled, 3F8/IRQ4 , 3E8/IRQ4, 2E8/IRQ3. The options for Serial Port2
are Disabled, 2F8/IRQ3 , 3E8/IRQ4, and 2E8/IRQ3.