Supero Supero SUPERSERVER 6016T-T, User Manual

Page: 48 / 102

5-14
S
UPER
S
ERVER 6016T-T User's Manual
Reset Connector
The reset connector is located on pins
3 and 4 of JF1 and attaches to the
reset switch on the computer chas-
sis. See the table on the right for pin
defi nitions.
PW_ON Connector
The PW_ON connector is on pins 1
and 2 of JF1. This header should be
connected to the chassis power but-
ton. See the table on the right for pin
defi nitions.
5-9 Connector Defi nitions
ATX Power Connector
The primary power supply connector
(JPW1) on the X8DTL-i meets the SSI
EPS 12V specifi cation. Refer to the
table on the right for the pin defi nitions
of the ATX 24-pin power connector.
You must also connect the 8-pin
processor power connectors (JPW2/
JPW3) to your power supply. Refer
to the table below right for the main
power connector.
Required Connection
ATX Power 24-pin Connector
Pin Defi nitions
Pin# Defi nition Pin # Defi nition
13 +3.3V 1 +3.3V
14 -12V 2 +3.3V
15 COM 3 COM
16 PS_ON 4 +5V
17 COM 5 COM
18 COM 6 +5V
19 COM 7 COM
20 Res (NC) 8 PWR_OK
21 +5V 9 5VSB
22 +5V 10 +12V
23 +5V 11 +12V
24 COM 12 +3.3V
Reset Button
Pin Defi nitions
Pin# Defi nition
3 Reset
4 Ground
Power Button
Pin Defi nitions
Pin# Defi nition
1 PW_ON
2 Ground
Processor Power Connector
In addition to JPW1, the 12V 8-pin
processor power connectors at JPW2
and JPW3 must be connected to your
serverboard. Failure in doing so will
void the manufacturer warranty on
your power supply and serverboard.
See the table on the right for pin
defi nitions.
Processor Power
Connector
Pin Defi nitions
Pins Defi nition
1 through 4 Ground
5 through 8 +12V