Supero SUPERO SuperServer 5037MC-H8TRF, User Manual

Page: 24 / 98

2-10
S
UPER
S
ERVER 5037MC-H8TRF User's Manual
2-5 Checking the Motherboard Setup
After setting up the the system, you may need to open the unit to make sure all the
connections have been made.
Note: Before operating the system for the fi rst time, it is important to remove the
protective fi lm covering the ventilation openings on the top of the chassis. These
vents provide proper ventilation and cooling for the system.
Removing the Chassis Cover and Protective Film
1. Disconnect the chassis from any power source.
2. Remove the three screws that secure the top cover onto the chassis as il-
lustrated in Figure 2-8.
3. Lift the top cover up and off the chassis.
4. Peel off the protective fi lm covering the top cover and the top of the chassis
5. Check that all ventilation openings on the top cover and the top of the chassis
are clear and unobstructed.
Checking the Components and Setup
1. You may have a processor already installed into each of the motherboards.
Each processor should have its own heatsink attached. See Chapter 5 for
instructions on processor and heatsink installation.
2. Your server may have come with system memory already installed. Make
sure all DIMMs are fully seated in their slots. For details on adding system
memory, refer to Chapter 5.
3. If desired, you can install add-on cards to the system. See Chapter 5 for
details on installing PCI add-on cards.
4. Make sure all power and data cables are properly connected and not blocking
the chassis air fl ow. See Chapter 5 for details on cable connections.