Supero SUPER P4SDA+, User Manual

Page: 44 / 92

2-18
S
UPER P4SDA+/P4SDM User's Manual
AGP Pro/4xAGP Slot (1.5V only)
The AGP Pro slot is backward compatible with AGP Pro and 4xAGP
graphics cards, which have fewer pins than AGP Pro cards. Because of
this, care must be taken when installing a graphics card into this slot, as
doing so incorrectly can damage your motherboard. For AGP Pro cards,
you should remove the orange sticker covering one end of the slot. For
other cards, leave this sticker in place and make sure your card does not
plug into the section it covers. A general rule of thumb is to make sure
your card fills the center section of pins first, then the end toward the
edge of the motherboard if there are more. If the I/O shield of your card
is flush with the edge of the motherboard, the card should be inserted
correctly.
IDE Connectors
There are no jumpers to config-
ure the onboard IDE interfaces
J6 and J7. See the table on the
left for pin definitions. You
must use the ATA100/66 cable
included with your system to
b e n e f i t f r o m t h e A T A 1 0 0 / 6 6
technology.
P in N u m b e r F u n ctio n
1 R e se t ID E
3 H o st D a ta 7
5 H o st D a ta 6
7 H o st D a ta 5
9 H o st D a ta 4
1 1 H o st D a ta 3
1 3 H o st D a ta 2
1 5 H o st D a ta 1
1 7 H o st D a ta 0
1 9 G N D
2 1 D R Q 3
2 3 I/O W rite -
2 5 I/O R e a d -
2 7 IO C H R D Y
2 9 D A C K 3 -
3 1 IR Q 1 4
3 3 A d d r 1
3 5 A d d r 0
3 7 C h ip S e le c t 0
3 9 A ctivity
P in N u m b e r F u n ctio n
2 G N D
4 H o st D a ta 8
6 H o st D a ta 9
8 H o st D a ta 1 0
1 0 H o st D a ta 1 1
1 2 H o st D a ta 1 2
1 4 H o st D a ta 1 3
1 6 H o st D a ta 1 4
1 8 H o st D a ta 1 5
2 0 K e y
2 2 G N D
2 4 G N D
2 6 G N D
2 8 B A L E
3 0 G N D
3 2 IO C S 1 6 -
3 4 G N D
3 6 A d d r 2
3 8 C h ip S e le c t 1 -
4 0 G N D
ID E C o n n e c to r P in D e fin itio n s
(J 6 , J 7 )