Supero SUPER P4SDA+, User Manual

Page: 31 / 92

Chapter 2: Installation
2-5
2-4 Installing DDR Memory
CAUTION
Exercise extreme care when installing or removing memory
modules to prevent any possible damage.
Memory Module Installation (See Figure 2-2)
1. Insert each DDR memory module vertically into its slot. Pay attention
to the notch along the bottom of the module to prevent inserting the
module incorrectly. (See support information below.)
2. Gently press down on the memory module until it snaps into place.
3. Three 184-pin memory sockets support up to 2 GB unbuffered
PC1600 and PC2100 DDR SDRAM. ECC type memory is supported.
Support
The P4SDA+/P4SDM supports both double-sided and single-sided
unbuffered PC1600 and PC2100 DDR SDRAM memory modules. You
should always populate DIMM1 first. DIMM1 can accept either a
single or a double sided module. If you are using at least one
double, put it into DIMM1. Then, if you are adding another double, it
should go in DIMM2 and DIMM3 must remain empty. Or, you may
populate both DIMM2 and DIMM3 with singles after DIMM1 is already
populated.
To Install:
Insert module
vertically and
press down
until it snaps
into place.
Pay attention
to the notch.
Figure 2-2a. Side View of DDR Module Installation into Slot