Supero SUPER P4DME-M, User Manual

Page: 39 / 86

Chapter 2: Installation
2-15
Mb LAN Enable/Disable
Change the setting of jumper JP3
to enable or disable the Mb LAN
port on the motherboard (see Fig-
ure 2-3 for location). Refer to the
table on the right for jumper set-
tings. The default setting is En-
abled.
Ju m p e r
P o sitio n
P in s 1 -2
P in s 2 -3
D e fin itio n
E n a b le d
D isa b le d
M b L A N
E n a b le /D is a b le
J u m p e r S e tting s
(J P 3 )
Gb LAN Enable/Disable
(P4DMS-6GM only)
Change the setting of jumper JD3
to enable or disable the Gb LAN
port on the motherboard. (see Fig-
ure 2-3 for location). Refer to the
table on the right for jumper set-
tings. The default setting is En-
abled.
Ju m p e r
P o sitio n
P in s 1 -2
P in s 2 -3
D e fin itio n
E n a b le d
D isa b le d
G b L A N
E n a b le /D is a b le
J u m p e r S e tting s
(J D 3 )
VGA Enable/Disable
JP4 allows you to enable or disable
the VGA port. The default position
is on pins 1 and 2 to enable VGA.
S e e t h e t a b l e o n t h e r i g h t f o r
jumper settings.
Ju m p e r
P o sitio n
1 -2
2 -3
D e fin itio n
E n a b le d
D isa b le d
V G A E n a b le /D is a b le
J u m p e r S e tting s
(J P 4 )
Third Power Supply Alarm
Enable/Disable
The system will notify you in the
event of a power supply failure.
This feature assumes that three
power supply units are installed in
the chassis, with one acting as a
backup. If you only have one or
two power supply units installed,
you should disable this (the default
setting) with JP9 to prevent false
alarms. See the table on the right
for jumper settings.
Ju m p e r
P o sitio n
O p e n
C lo se d
D e fin itio n
D isa b le d
E n a b le d
T h ird P o w e r S u p p ly
A la rm E n a b le /D is a b le
J u m p e r S e ttin g s (J P 9 )