Supero 5018A-FTN4, User Manual

Page: 71 / 114

Chapter 6: Advanced Chassis Setup
6-9
6-8 Power Supply
The SC505 chassis has a 200 Watt power supply that is auto-switching capable.
This enables it to automatically sense and operate at a 100v to 240v input voltage.
In the unlikely event that the power supply module fails, the system will shut down
and you must to replace the power supply module. New units can be ordered directly
from Supermicro at http://www.supermicro.com.
Replacing the Power Supply
Replacing the Power Supply
1. Power down the system and remove the cover.
2. Disconnect all wiring from the power supply.
3. Remove the four screws that hold the power supply in the chassis. Two rear
mounting screws are located on the rear of the power supply. Two bottom
mounting screws are accessed on the underside of the chassis and extend
upwards through the mounting thru holes to hold the power supply in place.
Set these screws aside for later use. See the
fi gure on the following page.
4. Remove the power supply from the chassis.
5. Align the mounting thru holes on the new power supply with the mounting
holes in the chassis and reattach the power supply to the chassis using the
four screws that were previously set aside.
6. Reconnect the wiring and the power cord to the power supply, replace the
cover and power up the server.