Super X12SPG-NF User's Manual
78
*If the feature above is set to Disabled or PXE, the following feature is available for
configuration:
AOC-ATG-i2T LAN2 OPROM
Use this feature to select which firmware type to be loaded for the add-on card in this slot.
The options are
Disabled
and PXE
(if the Boot Mode Select feature under the Boot tab is
set to Legacy),
Disabled
and EFI (if the Boot Mode Select feature under the Boot tab is set
to UEFI), and
Disabled
and PXE (if the Boot Mode Select feature under the Boot tab is set
to Dual).
NVMe0/NVMe1 Option ROM
Use this feature to select a desired firmware function to be loaded for the specified NVMe
slot. The options are Disabled and
Legacy
(if the Boot Mode Select feature under the Boot
tab is set to Legacy), Disabled and
EFI
(if the Boot Mode Select feature under the Boot tab
is set to UEFI), and Disabled,
Legacy
, and EFI (if the Boot Mode Select feature under the
Boot tab is set to Dual).
Super IO Configuration
The following Super IO information is display:
•
Super IO Chip AST2500
Serial Port 1 Configuration
This submenu allows you to configure the settings of Serial Port 1.
Serial Port 1
Select Enabled to enable the selected onboard serial port. The options are Disabled and
Enabled
.
Device Settings
This feature displays the status of the serial port.
Change Settings
This feature specifies the base I/O port address and the Interrupt Request address of the
serial port. Select
Auto to allow the BIOS to automatically assign the base I/O and IRQ
address. The options are
Auto
, (IO=3F8h; IRQ=4;), (IO=2F8h; IRQ=4;), (IO=3E8h; IRQ=4;),
and (IO=2E8h; IRQ=4;).
SOL Configuration
This submenu allows you to configure the settings of Serial Port 2.
