Chapter 4: BIOS
75
sSATA RAID Option ROM/UEFI Driver
Select UEFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable,
EFI
, and Legacy.
S-SATA0/S-SATA1
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
•
Software Preserve Support
S-SATA0/S-SATA1 Hot Plug
Set this feature to Enable for hot plug support, which allows you to replace a SATA drive
without shutting down the system. The options are Disable and
Enable
.
Spin Up Device
Set this feature to enable or disable the PCH to initialize the device. The options are
Disable
and Enable.
sSATA Device Type
Use this feature to specify if the SATA port specified should be connected to a Solid State
Drive or a Hard Disk Drive. The options are
Hard Disk Drive
and Solid State Drive.
Network Configuration
Network Stack
Select Enabled to enable Preboot Execution Environment (PXE) or Unified Extensible
Firmware Interface (UEFI) for network stack support. The options are Disabled and
Enabled
.
IPv4 PXE Support
Select Enabled to enable IPv4 PXE boot support. The options are Disabled and
Enabled
.
IPv4 HTTP Support
Select Enabled to enable IPv4 HTTP boot support. The options are
Disabled
and Enabled.
IPv6 PXE Support
Select Enabled to enable IPv6 PXE boot support. The options are Disabled and
Enabled
.
IPv6 HTTP Support
Select Enabled to enable IPv6 HTTP boot support. The options are
Disabled
and Enabled.
PXE Boot Wait Time
Use this option to specify the wait time to press the ESC key to abort the PXE boot. Press
"+" or "-" on your keyboard to change the value. The default setting is
0
.
