Super X12SPG-NF User's Manual
58
Wait For "F1" If Error
Use this feature to force the system to wait until the "F1" key is pressed if an error occurs.
The options are
Disabled
and Enabled.
INT19 (Interrupt 19) Trap Response
Interrupt 19 is the software interrupt that handles the boot disk function. When this feature
is set to Immediate, the ROM BIOS of the host adapters will "capture" Interrupt 19 at boot
up immediately and allow the drives that are attached to these host adapters to function as
bootable disks. If this feature is set to Postponed, the ROM BIOS of the host adapters will not
capture Interrupt 19 immediately and allow the drives attached to these adapters to function
as bootable devices at boot up. The options are
Immediate
and Postponed.
Re-try Boot
If this feature is enabled, the BIOS automatically reboots the system from a specified boot
device after its initial boot failure. The options are
Disabled
, Legacy Boot, and EFI Boot.
Power Configuration
Watch Dog Function
If enabled, the Watch Dog Timer allows the system to reset or generate NMI based on jumper
settings when it is expired for more than five minutes. The options are
Disabled
and Enabled
.
*If the feature above is set to Enabled, Watch Dog Action is available for configuration:
Watch Dog Action
Use this feature to reset the system or generate NMI. The options are
Reset
and NMI.
Front USB Port(s)
Use this feature to enable or disable front USB ports. If this feature is set to Enabled (Dynamic),
then front USB ports can be enabled or disabled with resetting the system. The options are
Enabled,
Disabled, and Enabled (Dynamic).
Rear USB Port(s)
Use this feature to enable or disable rear USB ports. If this feature is set to Enabled (Dynamic),
then rear USB ports can be enabled or disabled with resetting the system. The options are
Enabled,
Disabled, and Enabled (Dynamic).
Restore on AC Power Loss
Use this feature to set the power state after a power outage. Select Stay Off for the system
power to remain off after a power loss. Select Power On for the system power to be turned
on after a power loss. Select Last State to allow the system to resume its last power state
before a power loss. The options are Stay Off, Power On, and
Last State
.
