Supermicro SUPERSERVER 6036ST-6LR, User Manual, Page: 54 / 110

5-6
S
UPER
S
ERVER 6036ST-6LR User's Manual
Memory Support
The X8DTS-F supports up to 48 GB of ECC registered DDR3-1333/1066/800 or up
to 24 GB of ECC/non-ECC unbuffered DDR3-1333/1066/800 SDRAM in six DIMM
slots. Use memory modules of the same type and speed. See the following tables
for memory installation.
DIMM Installation
Installing Memory Modules
1. Insert the desired number of DIMMs into the memory slots starting with
DIMM #P1-DIMM1A. For optimal memory performance, please install a pair
(or pairs) of memory modules of the same type and speed (see the Memory
Installation Table below).
2. Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to avoid installing incorrectly (see Figure 5-3).
3. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules.
Caution:
Exercise extreme care when installing or removing DIMM modules to prevent
any possible damage.
5-4 Installing Memory
To Install:
Insert module vertically
and press down until it
snaps into place. Pay at-
tention to the alignment
notch at the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Figure 5-3. DIMM Installation
Top View of DDR3 Slot
Release Tab Release Tab
Note:
Notch should align with the receptive key point on the slot.
Notch
Notch
Front View