Supermicro SUPERSERVER 6036ST-6LR, User Manual, Page: 21 / 110

Chapter 2: Server Installation
2-7
2-6 Checking the Serverboard Setup
After you install the 6036ST-6LR in the rack, you will need to open the unit to
make sure the serverboard is properly installed and all the connections have been
made.
Accessing the Inside of the System (Figure 2-4)
1. Remove the two screws that secure the top cover of the chassis.
2. Slide the cover toward the rear of the chassis and lift the cover off the unit.
Checking the Components and Setup
1. You may have one or two processors already installed into the serverboard.
Each processor needs its own heat sink. See Chapter 5 for instructions on
processor and heat sink installation.
2. Your 6036ST-6LR server system may have come with system memory al-
ready installed. Make sure all DIMMs are fully seated in their slots. For details
on adding system memory, refer to Chapter 5.
3. If desired, you can install PCI expansion cards to the system. See Chapter 5
for details on installing PCI expansion cards.
4. Make sure all power and data cables are properly connected and not blocking
the chassis air fl ow. Also make sure that no cables are positioned in front of
the fans. See Chapter 5 for details on cable connections.
Warning:
Except for short periods of time, do NOT operate the server without the
cover in place. The chassis cover must be in place to allow proper air fl ow and prevent
overheating.