Supermicro SUPERSERVER 6015V-MR, User Manual

Page: 65 / 114

Chapter 6: Advanced Chassis Setup
6-5
To add a new SATA drive, install a drive into the tray with the printed circuit board
side facing down and so that the mounting holes align with those in the tray. Secure
the drive to the tray with the four screws. Replace the top cover when fi nished.
See Figure 6-3.
Note: the 6015V-MRLP can accommodate two internal SATA hard drives, one on
each side of the fans.
DVD-ROM Drive Installation
The top cover of the chassis must be opened to gain full access to the DVD-ROM
drive bay. The DVD-ROM must have a "slim" profi le to fi t into the 6015V-MR/6015V-
MRLP. If you cannot remove the top cover with the system remaining in the rack,
follow the procedure below.
First, shutdown the system and disconnect all cables from the back of the server
chassis. Make sure the system is supported from underneath then remove the
front bracket screws that secure the unit to the rack. Carefully lift the server out
of the rack.
Open the cover by following the procedure described in Section 6-5. You must
power down the system before installing or removing DVD-ROM or Serial ATA
drives. Remove the screws that secure the DVD-ROM drive to the chassis and
then lift the drive out of the chassis. See Figure 6-3.
Note: A red mark on a wire typically designates the location of pin 1.