Supermicro SUPERSERVER 6015V-M3, User Manual

Page: 64 / 122

6-6
S
UPER
S
ERVER 6015V-M3/6015V-MT User's Manual
DVD-ROM Drive Installation
The top cover of the chassis must be opened to gain full access to the DVD-ROM
drive bay. The 6015V-M3/6015V-MT accommodates only slim DVD-ROM drives.
Side mounting brackets are needed to mount a slim DVD-ROM drive in the 6015V-
M3/6015V-MT server.
You must power down the system before installing or removing a DVD-ROM drive.
First, release the retention screws that secure the server unit to the rack. Grasp
the two handles on either side and pull the unit straight out until it locks (you will
hear a "click"). Next, depress the two buttons on the top of the chassis to release
the top cover and at the same time, push the cover away from you until it stops.
You can then lift the top cover from the chassis to gain full access to the inside of
the server.
With the chassis cover removed, unplug the power and data cables from the drive.
Then locate the locking tab at the rear of the drive. It will be on the left side of the
drive when viewed from the front of the chassis. Pull the tab away from the drive
and push the drive unit out the front of the chassis. Add a new drive by following
this procedure in reverse order. You may hear a faint *click* of the locking tab when
the drive is fully inserted. Remember to reconnect the data and power cables to the
drive before replacing the chassis cover and restoring power to the system.