Supermicro SUPERSERVER 5028TK-HTR, User Manual

Page: 78 / 138

6-14
SUPERSERVER 5028TK-HTR/HTTR User's Manual
Installing an Add-on Card
The chassis includes I/O slots for PCI add-on cards. Each side supports
one low profile/half length add-on card for a total of four per chassis, one per drawer.
Installing Add-on Cards (Figure 6-12)
1. Disconnect the power supply, lay the chassis on a flat surface, and open the
chassis cover.
2. Pull open the add-on card slot clip in the rear of the chassis.
3. Slide the temporary PCI slot shield toward the slot clip and remove the
temporary shield from the chassis.
4. Connect the add-on card to the riser card.
5. Secure the riser card to the serverboard tray using the riser card screw.
6. Slide the add-on card bracket into the rear add-on card slot and secure with
the add-on card bracket screws.
7. Close the add-on card slot clip.
Note:
Under normal circumstances, the riser card and add-on card bracket are
not separated.
Figure 6-12. Installing a Low Profile Add-On Card
Riser Card
Add-on Card