Supermicro SUPERSERVER 5028TK-HTR, User Manual

Page: 108 / 138

7-24
SUPERSERVER 5028TK-HTR/HTTR User's Manual
(Port 0~ Port 5 ) sSATA Device Type (Available when an sSATA port is
detected)
Use this item to specify if the sSATA port specified by the user should be con -
nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk
Drive and Solid State Drive.
*If the item above "Configure sSATA as" is set to RAID, the following items will
display:
Aggressive Link Power Management
When this item is set to Enabled, the sSATA AHCI controller manages the power
usage of the sSATA link. The controller will put the link to a low power state when
the I/O is inactive for an extended period of time, and the power state will return
to normal when the I/O becomes active. The options are Enabled and Disabled.
s SATAPort 0~ Port 5
This item displays the information detected on the sSATA drive connected to the
particular sSATA port specified by the user.
•
Model number of drive and capacity
•
Software Preserve Support
sSATA Port 0~ Port 5
Select Enabled to enable a SATA port specified by the user. The options are Dis -
abled and Enabled .
(Port 0 ~ Port 5) Hot Plug
Select Enabled to enable hot-plugging support for a port specified by the user,
which will allow the user to replace a SATA disk drive installed on this port without
shutting down the system. The options are Enabled and
Disabled
.
(Port 0 ~ Port 5) Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization to the device. The options are Enabled and
Disabled .
(Port 0 ~ Port 5) sSATA Device Type
Use this item to specify if the sSATA port specified by the user should be con -
nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk
Drive and Solid State Drive.