Supermicro SUPERSERVER 5028TK-HTR, User Manual

Page: 58 / 138

5-8
SUPERSERVER 5028TK-HTR/HTTR User's Manual
5-8 Connector Definitions
Universal Serial Bus (USB)
Two USB 3.0 ports (USB 0/1) are
located on the rear I/O panel and
two Type-A 3.0 USB headers (USB2,
USB3) are located on the motherboard.
Connect appropriate cables to these
USB connections for USB support.
(Cables are not included.) See the
table on the right for pin definitions.
USB
Pin Definitions
Pin# Definition Pin# Definition
1 +5V 6 RX+
2 D- 7 Ground
3 D+ 8 TX-
4 Ground 9 TX+
5 RX-
Add-on Card Connector
Pin Definitions (JF1)
Pin # Definition Pin # Definition
S1 FP_PWRBTN_N S20 LINK_ACT_N
S2 FP_PWR_LED_N S19 UID_SW_FP_N
S3 PS_ON_N S18 UID_BMC_N
S4 P12V_ENABLED S17 PWM1_HWM
S5 No Connection S16 TACHO_A1
S6 PMBCLK_PS S15 TACHO_A2
S7 PMBDAT_PS S14 RED_LED_ON_N
S8 PS_PWRFAIL_N S13 P5V_STBY
S9 No Connection S12 P5V_STBY
S10 No Connection S11 No Connection
Add-on Card Connector
Pin Definitions (JF1)
Pin # Definition Pin # Definition
P1 P12V_IN P8 Ground
P2 P12V_IN P7 Ground
P3 P12V_IN P6 Ground
P4 P12V_IN P5 Ground
Ethernet Port/IPMI LAN
Two Ethernet ports (LAN1/LAN2) are located on the rear I/O panel. These LAN
ports provide Gigabit (GbE) LAN support on the K1SPi and 10-Gigabit (10GbE) LAN
support on the K1SPi-T. In addition, a dedicated IPMI LAN port is located next to
the VGA port to provide KVM support for IPMI 2.0. These NIC ports accept RJ45-
type cables. Please refer to the LED Indicator section for LAN LED information.
Add-on Card Connector (JF1)
The JF1 add-on card header provides front access to the power supply and the front
panel control connections for the K1SPi/K1SPi-T motherboard. Insert an add-on
card into this connector for the support of PMBus, LED signals, button signals, fan
speed, fan PWM, 5V standby power, and 12V power. This connector is designed
specifically for a Supermicro-proprietary add-on card. Refer to the layout below for
the location of JF1.