Supermicro SC816LTS-655BP, User Manual

Page: 54 / 104

5-8
SUPERSERVER 5017R-iHDP User's Manual
5-6 Installing Memory
Note
: Check the Supermicro web site for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMMs to
prevent any possible damage.
To Install: Insert
module vertically
and press down
until it snaps into
place. Pay attention
to the alignment
notch at the bottom.
To Remove:
Use your thumbs to
gently push the re-
lease tabs near both
ends of the module.
This should release
it from the slot.
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with
DIMMB1 (blue slot), then DIMMB2, DIMMA1, DIMMA2. Pay attention to the
notch along the bottom of the module to prevent incorrect installation.
2. Insert each DIMM module vertically and snap it into place. Repeat step 1 to
install more memory, if needed. See instructions on the next page.
Figure 5-34 DIMM Installation
Top View of DDR3 Slot
Release Tab
Release Tab
Note: Notch should
align with the receptive
key point on the slot.
Notch
Notch
Front View