Supermicro SC816LTS-655BP, User Manual

Page: 62 / 104

5-16
SUPERSERVER 5017R-iHDP User's Manual
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is
enables. See the table on the right for
jumper settings.
VGA Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog
JWD1 enables the Watch Dog func-
tion, a system monitor that takes action
when a software application freezes
the system. Jumping pins 1-2 will have
WD reboot the system if a program
freezes. Jumping pins 2-3 will gener-
ate a non-maskable interrupt for the
program that has frozen. See the table
on the right for jumper settings. Watch
Dog must also be enabled in BIOS.
Note: when Watch Dog is enabled, the user
must write their own application software to
disable the Watch Dog Timer.
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
SMB Bus to PCI Slots
Jumpers JI2C1 and JI2C2 allow you
to connect the System Management
Bus (SMB) to PCI-E and PCI slots.
The default setting is set to
Disabled .
See the table on the right for jumper
settings.
I2C to PCI-Slots (JI2C)
Jumper Settings
Jumper Definition
On Enabled
Off Disabled (Default)
ME Recovery
When enabled, Intel ME Recovery
(JPME1) is used to update the ME
(Management Engine) firmware. When
disabled, the firmware is protected.
ME Recovery
(JPME1)
Pin# Definition
1-2 Normal (Default)
2-3 ME Recovery