A+ Server AS -4124GO-NART/AS -4124GO-NART+ User's Manual
56
Installing an Expansion Card in the Switch Tray
1. Power down the system and remove the switch tray as described in Section 3.1 and 3.2.
2. Remove the shield and screw where the expansion card will be installed.
3. Install the expansion card and re-install the screw.
Figure 3-17. Remove Shield and Screw
Figure 3-18. Install Card and Screw
Figure 3-19. Remove Shield
Figure 3-20. Install AIOM
Installing AIOM in the Switch Tray
1. Power down the system and remove the switch tray as described in Section 3.1 and 3.2.
2. Loosen the thumbscrew on the AIOM shield and remove it from the chassis.
3. Push the AIOM card into the chassis until the release lever retracts.
4. Tighten the thumbscrew to secure the AIOM card in the chassis.
Release Tab
Screw
Thumbscrew
Thumbscrew
Summary of Contents for A+
Page 1: ...USER S MANUAL Revision 1 0b A Server AS 4124GO NART AS 4124GO NART ...
Page 14: ...14 A Server AS 4124GO NART AS 4124GO NART User s Manual Figure 1 6 Motherboard Block Diagram ...
Page 95: ...Chapter 4 UEFI BIOS 95 Save Changes and Exit Use this item to save the changes above and exit ...
