SuperiorFireplaces.us.com
127035-01K
14
INSTALLATION
Continued
The draft shield kit should be installed after the fireplace is completely
framed and finished. The brackets are attached to the front side face
of the fireplace using two screws as shown in
Figure 25a
. Position
the glass panel in the bracket so that it is securely in place. The glass
panel can be placed in two different height locations.
GAS CONTROL MODULE SYSTEM
REMOTE CONTROL FEATURE
The module has a built in remote control receiver that allows the
user to program the remote transmitter at any time during or after
the installation of the burner.
1. There is a switch located on the right side of the module that
reads REMOTE/OFF
(Figure 26)
.
2. When the remote/off switch is in the OFF position, the burner
will operate from the rocker switch or wall switch connected to
the two BROWN wires on the module.
3. When the remote/off is in the REMOTE position the burner will
operate from the Remote Control Transmitter.
NOTE:
The module must be programmed to the Remote Control
Transmitter.
• To program the module (make sure the system has power),
locate the learn button
(Figure 27)
on the module. Locate the
metal shield that is covering the module and remove the screw
on top. Use a small thin object like a paper clip (not sharp points)
to press and release the learn button. There will be a beep sound
from the module. Then press any button on the remote transmit-
ter. Once the module's internal receiver accepts the transmitter
code, there will be a series of confirming beeps.
• The remote system is ready for use.
• Pushing and holding the LEARN button for 6 seconds will result
in clearing the transmitter security code from the module's
memory. The module will make three long beeps in succession
when it has been cleared.
Figure 27 - Gas Module Left Side
IGNITER ASSEMBLY
The igniter assembly is factory preset for proper ignition of the burner.
Alterations may have occurred during shipping and handling. Call a
qualified service person to readjust the igniter assembly if necessary.
The igniter should be positioned as shown in
Figure 28
.
NOTE:
Figure 28
, shows the correct positioning of the igniter and
sensing rod.
If your igniter assembly does not meet these requirements:
• turn appliance off
(see To Turn Off Gas to Appliance, Page 15).
• see Troubleshooting,
Page 18
.
Figure 28 - Igniter
NOTE:
Reference only, not to scale
Igniter
Ground
Electrode
Sensing
Rod
0.8000
Spark Gap
0.120
Figure 25a - Installing Draft Shield Kit
Glass Panel
Bracket
Screws
Figure 26 - Gas Module Right Side
Continuous Pilot
Off/On Switch
Remote/Off
Switch
“S” Pilot
Connection
“I” Pilot
Connection
ADJ.
Learn Button
AUX Connection
WARNING: Do not change or substitute glass
pebbles provided with this fireplace. If replacing, use
only replacement glass pebbles. See Parts
Page 22
.
Discontinue use of the appliance immediately if glass panel is
damaged and contact a qualified installer for repair. Only glass
panel certified with the appliance shall be used.
DRAFT SHIELD KIT INSTALLATION (F1031)
