11
AVSI-12 Interview Room System Setup and User Guide
SECTION 3: SYSTEM SETUP
AUDIOADAPTER Cable to speakers
AUDIO OUT connector
2.
Plug the power adapter provided with the speakers into the power port on the back of the speakers.
3.5 Install the ALI-TS1012R camera and PA6IL microphone
When performing the following instructions, refer to the
ALI-TS1012R HD-TVI 2MP Indoor Dome Camera Quick Installation
Guide
provided with your camera for additional information.
1.
Mount the ALI-TS1012R camera in the interview room in accordance with the mounting guidelines provided in the
installation instructions. Ensure that the camera location will provide the best field of view of both the interviewer(s) and
those being interviewed. Note that the camera module is mounted on an internal gimbal to adjust it’s tilt and direction.
a.
After mounting the camera, leave the dome cover off. The camera direction and tilt will be adjusted after the recorder
is powered on.
2.
Install the PA6IL microphone to achieve optimal recording of the subject being interviewed and all other room occupants,
be away extraneous noise, such as from HVAC vents, fans and sounds outside the room, and in a location where it cannot be
easily tampered with. Do not install the microphone on the table where occupants can reach it. Both the camera drop cables
and the microphone drop cables must be able to connect to the same EXT100 video-audio-power extension cable.
3.
Route the EXT100 video, audio and power extension cable from the recorder to the camera and microphone. Notice that the
power connectors are different at the ends of the cable (see photo below). Ensure that the power connector on the recorder
end will mate with the connector on the DC12-2000R (2 amp) power adapter, and the power connector at the camera and
microphone end will connect to the YPOWER adapter.
