SWTL4510 Operation Manual
67
3) Clean the inner part of the separator with fuel.
4) Mount again the separator by tightening the ring again.
5) Release the handle to allow fuel into the separator.
6) Bleed the fuel circuit by turning a while ignition key to position START
during 20 seconds.
•
Before precede to clean the separator cool down the engine.
•
After bleeding the circuit, turn the ignition key to preheating position for 2 minutes
and then start the engine.
•
Take into consideration that fuel is a flammable fluid. Clean the spilled fuel in
order to prevent risk of fire.
6.5.5.2 CHECK THE TIGHTENESS OF PUMP FIXING SCREWS
•
Check and if necessary tighten the screws of the gear pump fixing point.
•
Take as reference the driving torque shown in the following tables:
Driving Torque for Piston Pump Elastic
Coupler
Driving Torque for Gear Pump Piston
Pump
XX Nm
XX Nm
6.5.5.3 CHECKING THE FLUID LEVEL OF THE BATTERY
For checking the fluid level of the battery proceed as follow:
1) Open the plug on the topside of the battery.
2) Check the acid level. The acid level has to be 6 mm above the plate edge.
3) Refill with distilled water if necessary.
4) Put back and tighten the plug.
•
Follow all the security regulation describes in the section 1.2.4
