SWTL4518 Operation & Maintenance Manual
18
2.4
LIFTING OF THE MACHINE
•
Before lifting the machine, make sure nobody can approach the lifting area. While lifting
the machine, make sure nobody is under the machine and vicinal area.
•
The operator must leave the machine before lifting.
•
Only use homologated eyebolts and sufficient cables.
•
Make sure the lifting equipment have enough capacity to lift the machine
•
Eyebolts are not supplied by Sunward normally. The owner of the machine is
responsible for install the eyebolts on the cabin roof.
•
The eyebolts must be installed properly on the four installing block on the roof of cabin.
1)
Lower the bucket to the ground and fold it completely.
2)
Raise the restrain bar and stop the engine.
3)
Fix the eyebolts to the installing blocks.
4)
Insert the cables into the eyebolts and fix them tighten.
5)
Connect the cables to the upper lifting ring.
6)
Lift the machine slowly and keep the machine balance during whole lifting
progress.
2.5
LONG TERM STORAGE OF THE MACHINE
2.5.1 Before Long Term Storage
Carry out the following steps before long term storage of the machine:
y
Store the machine in place of safety. Lower boom and put the bucket on ground flatly.
y
Clean the machine completely.
y
Empty and replace all the liquid of the machine (such as engine oil, cooling oil, hydraulic oil,
main driven oil etc.). Fill in special anti corrosive coolant and special fuel oil of protection.
