SWTL4510 Operation Manual
32
seat backward and forward till you find the best position for you, then release the
adjusting handle. The locking pin will be engaged after release adjusting handle. Try to
move the seat after your adjusting the seat’s position to make sure that the seat is locked
well again. It may lead to injury without this confirmation.
4.5
INSTRUMENTS
Instruments in cab
1) Coolant Temperature Gauge
This indicator shows the
temperature of the engine coolant. Normally the engine
coolant temperature should be 80-
85
°
C while the engine
operating. Warm up engine is necessary when start engine.
Please keep the engine run with idle after start engine until
the coolant temperature reaches the green range then start to
work with the machine. Once the temperature reaches the
overheating red range, stop the engine immediately.
2) Fuel Level Gauge
This indicator shows the fuel level. The capacity of the fuel tank is about
70 liters. The red range indicates that the fuel level is less than 8
liters. When the machine is
work, once the indicator reaches the red range, stop the engine and refuel it.
3) Hour meter
The hour meter indicates the total number of hours of engine running. The hour
meter keeps in function while the engine is running independent on engine rotating speed and
working situation.
4) Battery warning light:
In normal condition, warning light will be flash in starting circuit,
and will extinguish when engine reach normal speed. If light is still flash when engine running
at normal speed, it means engine does not work or battery wrong connection. When ignition key
turned to “ON” position, but warning light is still flash, it means battery does not work normally.
5) Preheating warning light:
it will be flash in ignition key turned to preheating position and
will extinguish when ignition key turned over preheating position after several seconds.
6) Engine oil pressure warning light:
it will be flash when start engine and will extinguish
immediately after engine running; if it is still flash in engine running, please stop engine at once
and check failure.
7) Air filter plug warning light:
it will be flash when air filter plugged, stop engine and check
air filter.
8) Hydraulic oil filter plug warning light:
it will be flash when hydraulic oil filter plugged,
check oil filter; in normal status, it will need to replace oil filter.
9) Direction warning light:
it will be flash when direction switch or emergency button action.
10) Brake warning light:
it will be flash when press down park button, and will extinguish
when loosen the button
。
11) Work warning light:
it will be flash when work light is opened
。
