Doc. Title
Author
Page of Pages
ST310U OPERATION MANUAL
JH KIM
56 of 66
Concerning
Doc. No.
Rev.
Date
Features and How to set parameters
1.08
2017/7/13
Suntech International Ltd.
Confidential Document
8. Detailed Description on Event Lines and Features
8-1. Total 5 pin Event Lines
Red
Car battery (Main power 8V ~ 40V)
FIX wire
BLK
Ground
FIX wire
WHT
Input 1 (Digital input or Ignition)
FIX wire
ORG
Output 1
FIX wire
YEL
Input 2 (Digital input)
Fix wire
The Input lines were designed to endure up to 50V. The Output lines can endure up to 30V.
8-1-1. Immobilizer
If Output type is set to
‘Immobilizer’ or ‘Immobilizer & Auto Active’ and you connect this line to immobilize the
vehicle, the Output line can use the immobilizer.
When the device recognizes the command to activate the immobilizer output, one of the 2 options (
‘Active’ or
‘Inactive’) will be selected. Which activation you choose will depend on what mode the vehicle is in a parking mode
or in a driving mode.
In case of driving, the immobilizer activation is made in a way of progressive blocking as shown the following
blinking diagram:
The active time of the immobilizer is increased by 90ms each 4s. Three (3) minutes later, the immobilizer starts
being activated and will be activated continuously.
However, in case of parking as soon as the vehicle is parked, the immobilizer is activated normally.
In a case that the Output type is set to
‘Immobilizer & Auto active’, the output is activated automatically as long as
the vehicle is parked. In such a case the Output is also activated as long as the vehicle starts being in a driving
mode.
If the device receives a command to activate the immobilizer output, the output is always activated regardless to a
mode type (either parking mode or driving mode).
