Doc. Title
Author
Page of Pages
ST310U OPERATION MANUAL
JH KIM
13 of 66
Concerning
Doc. No.
Rev.
Date
Features and How to set parameters
1.08
2017/7/13
Suntech International Ltd.
Confidential Document
T4
String
Sec
Interval to be set to send a Keep Alive string.
Range: 0 ~ 65500
SMS_T1
String
Min
Interval to be set to send a Status Report in parking mode
Range: 0 ~ 99999
SMS_T2
String
Min
Interval to be set to send a Status Report in driving mode
Range: 0 ~ 99999
SMS_PACK_NO
String
Report No in one SMS message
Range: 0 ~ 5
<Example>
[command] ST300RPT;100850000;02;180;120;60;3;0;0;0;0;0
[response] ST300RPT;Res;100850000;010;180;120;60;3;0;0;0;0;0
<Note>:
** If a reporting interval is set with a big number, the network may disconnect GPRS connection because GPRS
communication does not make a progress for a long time. So, the device may not receive the command via
GPRS. “T4” will be used to prevent such a disconnection by sending a short data for short time.
** The
‘Keep Alive’ report is sent only when the device has no data to be sent for the time of the interval ‘T4’.
4-3. Event Parameters
In order to set these parameters properly, read carefully the contents and <Example> along with <Note> described
in the bottom inside the table below.
HDR
DEV_ID
VER
IGNITION
T1
T2
IN1_TYPE
IN2_TYPE
IN3_TYPE
IN1_CHAT
IN2_CHAT
IN3_CHAT
OUT1_TYPE OUT2_TYPE OUT1_ACTIVE OUT2_ACTIVE
PULSE1_NO PULSE1_ON
PULSE1_OFF
PULSE2_NO
PULSE2_ON PULSE2_OFF
IN4_TYPE
IN5_TYPE
IN4_CHAT
IN5_CHAT
BAUD
Field
Marks
Value
Meaning
HDR
“ST300EVT”
Command type
DEV_ID
9 char.
Device ID
VER
“02”
Protocol Version
IGNITION
‘0’ ~ ‘3’
Ignition using state:
0 : Not use ignition
1 : Use ignition Line
2 : Virtual ignition(power)
3 : Virtual ignition (motion)
T1
String
Sec
Delay in entering parking mode after ignition goes to OFF
T2
String
Sec
Delay in entering driving mode after ignition goes to ON
