38
12) Setting X-Y Original Point
A. Setting X-shaft original point.
ⓐ
Remove the surface cover of X-fixing frame.
ⓑ
Move the upper feed plate to the center of X-shaft.
ⓒ
As in the figure, loosen the clamp screw of X-sensor bracket and place X-sensor plate attached on the X-timing belt fixing
plate block at the center of the sensor. And then fasten fixing screw.
B. Setting Y-shaft original point.
ⓐ
Move the upper feed plate to the center of Y-shaft.
ⓑ
As in the figure, loosen the clamp screw of Y-sensor bracket and place X-sensor plate at the center of the sensor. And then
fasten clamp screw.
[ Fig. 55 ]
Original point detection plate
Clamp screw
Sensor
Original point detection plat
Clamp
screw
[ Fig. 54 ]
Sensor
