Sunshine QJ-Y-2-35, Instruction Manual

Page: 16 / 56

15
3 、 After marking proper position for lift column, to draw with a rough outline of
column position with chalk, column base as a template.
4
、
Re-check all the dimensions to ensure that each column of the base shape and
position consistent with the chalk line.
5
、
Firstly, place cylinder in the positioning hole in the column bottom, then after fixing
slider to slide, push the slide to bottom of the column from top. Two columns distance
is 2800mm.
6
、
Base on column bottom hole for position, to drill a hole about 150 mm deep with
churn drill on concrete. To ensure the expansion bolts' fixed-strength, do not get churn
drill shaking when drilling hole. After drilling, with a vacuum cleaner or wire brush to
clean the dust of each hole. Ensure the column in the process to prevent the dumping
or shifting.
7
、
The nuts should be reserved 3-5mm thread after assembling expansion bolts. Inserted
into the drilled hole, tapping with a hammer until the bolt to the column bottom of the
spring washer parts, then taping pivot bolt until it can not move. Measured vertical
degree of vertical column with squareness gauge .If column vertical degree is large, use
pad to adjust. After vertical adjustment, tighten the nut bolt. nut tightening torque is
about 80N.M.
Anchor bolt installation drawings ：