Installation and Operation Manual
SA-07-11-87, Rev A
39
January 2019
1.04 (Not applicable to the Bearing Box
configuration)
Bolt the extended shaft motor to the
lifting hanger using the motor’s
integrated lifting feature holes (this
may require removal of the motor’s
“lifting ears”).
Note: Motor bolts DO NOT take
any vertical load and are
merely intended for anti-
rotation of the motor
assembly.
1.05 Secure the Lifting Hanger shackle to
an overhead lifting devise to prevent
the top assembly from tipping.
1.06 Select any (4) locking screws of the
Cartridge Seal Collar that are
spaced 90 ° and tighten them in an
alternating pattern from side to side
until the screw makes contact with
the shaft. DO NOT tighten the
screws at this time.
After the screws are in contact,
apply ½ the recommended torque in
the same alternating pattern.
Note: Refer to the seal
manufacturer drawing for
torque specifications
