![background image](http://html.mh-extra.com/html/sunbeam/snb652sia-series/snb652sia-series_service-manual_1393662020.webp)
Description of all Functions
3.2.1 - Interpretation and analysis of the fault codes
Door Open or not properly closed
VERY IMPORTANT: To analyse the error codes correctly, refer to the theoretical
electrical schema on page 39.
>
DOOR OPEN OR NOT
PROPERLY CLOSED
LUX
ECO - STANDARD
F1
1BEEP
X
X
X
X
X
X
1BEEP
If the door opens during the wash, or the door latch does not work, this will be detec-
ted.
If the machine detects that the door is open during the wash cycle, after 2 seconds,
the program will pause in that stage and beep as follows:
1 beep
Pause 4” 1 beep
pause 4”………and so on.
This means error code F1.
Possible causes:
1. Door not properly closed.
2. Fault in the door micro, whether mechanical or electrical. To check this
analysis it is advisable to bridge it electrically.
3. Faulty installation:
- Faulty cables (cut) from the door micro to the card.
- The cable is incorrectly
fi
tted into the connector,
J3 CONTACTS 1 and 9
.
Warning:
THE DELAY ON RE-STARTING is not a fault, it
is a SAFETY PRECAUTION.
If the door is opened during the wash, cold air enters the dishwasher interior. When
the door is closed again, to prevent this causing abnormal operation, the machine
pauses for a time which depends on the water temperature.
If the water temperature is below 45º, it will pause for 5 seconds.
If the water temperature is equal to or greater than 45º, it will pause for 3.5 seconds.
!