Sun Microsystems Sun StorEdge T3, Installation, Operation And Service Manual

Page: 94 / 148

3-10 Sun StorEdge T3 Disk Tray Installation, Operation, and Service Manual • July 2000
An SNMP MIB file is provided with the Sun StorEdge T3 disk tray for use with
SNMP-based applications. The MIB file is located in the following directory on the
disk tray:
/web/snmp/t300.mib
To use this file, ftp this MIB file from the disk tray to your SNMP management host
and refer to your specific SNMP management documentation for correct MIB file
installation procedures.
Note –
SNMP notification can be used in combination with the Component
Manager software.
3.3.3
syslog
Error Reports
A
syslog
daemon exists in the hardware RAID controller that records system
messages and provides for remote monitoring. There are four possible levels of
messages:
■
Error. Indicates a critical system event requiring immediate user intervention or
attention. (For example, an over-temperature condition or a removed FRU.)
■
Warning. Indicates a system event that will eventually require user intervention.
(For example, a FRU being disabled and a recovery procedure being executed.)
■
Notice. Indicates a system event that may be a side effect of other events or
possibly a normal condition. (For example, the power switch turned off.)
■
Information. Indicates a system event that has no effect on the health of the
system. (For example, the healthy state of a FRU.)
You can configure the level of error reporting to receive only certain types of
messages, such as error and warning messages only. For more information on
configuring remote system logging, refer to the Sun StorEdge T3 Disk Tray
Administrator’s Guide.