Sun Microsystems Sun Fire X4140, Service Manual

Page: 27 / 168

Chapter 2 Preparing to Service the System 2-3
▼
To View Chassis Serial Number
To view information about a system component, you need the Read Only (o) role
enabled.
1. Log in to the ILOM CLI.
2. At the prompt, type:
-> cd /SYS
/SYS
-> cd MB
/SYS/MB
-> show chassis_serial_number type
/SYS/MB
Properties:
chassis_serial_number = 0811QAD01C
type = Motherboard
For more information, see Sun Integrated Lights Out Manager (ILOM) 3.0 CLI
Procedures Guide (820-6412).
2.4 Powering Off the Server
To remove main power from the server, use one of the methods shown in the
following table.
TABLE 2-1
Shutdown Procedures
Shutdown Method
Graceful shutdown Use a pen, or other pointed object, to press and release the Power button on the
front panel. Pressing the power button causes Advanced Configuration and
Power Interface (ACPI)–enabled operating systems to perform an orderly
shutdown of the operating system. Servers not running ACPI-enabled operating
systems will shut down to standby power mode immediately.
Emergency shutdown Press and hold the Power button for at least four seconds until the main power is
off and the server enters standby power mode. See
FIGURE 2-2
.
When the main power is off, the Power/OK LED on the front panel flashes,
indicating that the server is in standby power mode.
Caution -
All applications and files will be closed abruptly without saving
changes. File system corruption might occur.
ILOM SP CLI shutdown See Section 2.4.1, “Powering Off the Server Using the Service Processor
Command Line” on page 2-5 .