Sun Microsystems Sun Fire V880z, Installation And User Manual

Page: 81 / 128

Chapter 8 Genlocking Sun XVR-4000 Graphics Accelerators 65
2. Connect the 13W3 connector end of the genlock cable to the Sun XVR-4000
graphics accelerator 13W3 monitor connector selected for genlocking (
FIGURE 8-2
).
3. Attach a BNC-T connector to the slave back panel genlock/BNC connector of the
Sun XVR-4000 graphics accelerator (
FIGURE 8-2
).
Repeat for each additional slave device to be genlocked.
4. Connect the proper BNC connector end of the genlock cable to one end of the
BNC-T connector (
FIGURE 8-2
).
The composite (or horizontal) synchronization signal is normally used for genlock
and is typically the BNC connector on the black wire. If the synchronization signal of
the master video format uses the
sync on green
option, use the BNC connector on
the green wire. (The genlock 13W3-BNC cable also has red, green, blue or white
BNC wires.) See
TABLE 8-1
on page 70.
5. For multiple slave devices, connect a BNC-BNC cable from the open end of the
BNC-T connector on one graphics accelerator to the BNC-T connector of the next
slave device.
6. Attach the 75-ohm terminator to the open BNC-T connector of the last slave
device.