Sun Microsystems SPARCstation 4, Service Manual

Page: 107 / 190

Chapter 9 Storage Devices 9-21
6. Detach the wrist strap and replace the cover.
See Chapter 7.
7. Power on the system.
See Section 6.2 “Powering On the System.”
9.7 CD-ROM Audio Cable
9.7.1 Removing the Audio Cable
1. Shut down and power off the system.
See Section 6.1 “Powering Off the System.”
2. Remove the cover and attach a wrist strap.
See Chapter 7.
3. Remove the SBus card (if present).
See Section 11.1.1 “Removing the SBus Card.”
4. Unplug the CD-ROM audio cable from the back of the CD-ROM drive.
FIGURE 9-20
CD-ROM Drive Rear Panel Connectors
5. Free the audio cable from the slot on the side of the Audio Module, and from
under the retaining hooks on the board guide.
See
FIGURE 9-21
.
6. Disconnect the audio cable from the connector on the Audio Module.
Gently pull the audio cable from underneath the Audio Module metal shield,
ensuring that the audio cable connector does not snag on any Audio Module
components. See
FIGURE 9-21
.
CD-ROM Audio Out connector